Page History

Description

The RealTimeConnector Timeseries Connector is the component responsible for managing the connection to a remote service and sending histories.

Implementation

• Drag and drop the TimeSeries Connector from the palette (btibMqtt, btibMongo, etc) to Services > Btib Service > External Connectors > TimeSeriesConnectors.
• Fill the adequate fields. Each RealTimeConnector TimeseriesConnector will have its specific fields.
• Enable the connector. It is also possible to ping the Connector to check if it works.

 PropertiesImage Removed

Image Added

• LogExt:  See LogExt.
• Status : Connection status.
• Enabled : Enable/Disable the component.
• Fault Cause : The error message status.
• Health: Status of the connector
• AlarmSourceInfo:  Allows to configure the alarm if there an error on ping
• Ping Monitor: allows to monitor the connector for problems. Note: The implementation of the ping and the alarm functionality in the monitor is connector-specific.
  • Ping Enabled: enable pinging when there's a problem.
  • Ping Frequency: the frequency at which to ping
  • Alarm on Failure: enable alarms when there's a failure
  • Startup Alarm Delay: the delay to startup the alarm

 Advanced Config

Image Removed

Image Removed

Image Removed

...

• LicenseMonitor: Component checking the license of the connector

Advanced Config

• Nan Values Policy: The policy for nan values (send or ignore).
• Infinite Values Policy: The policy for Infinite values (send or ignore)

...

• .

Actions

• Ping : Ping the Service.

...