Skip to main content
Skip table of contents

Pulse 4 Decoder

Summary

Pulse 4 sensors decoder



Usage

  1. Set up a RestQuery that recovers the Pulse 4 payload to decode
  2. Inside the RestQuery's Points, drag and drop a StringPoint from the palette
  3. Inside the Value Conversion slot of the point's Proxy Ext, Drag and Drop the V64ToJson component 

You should see the result of the conversion in your StringPoint's Out slot



JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close