Breadcrumbs

Timeseries Connector

Description

The Timeseries Connector is the component responsible for managing the connection to a remote service and sending histories.

Implementation

  • Drag and drop the TimeSeries Connector from the palette (btibMqtt, btibMongo, etc) to Services > Btib Service > External Connectors > TimeSeriesConnectors.

  • Fill the adequate fields. Each TimeseriesConnector will have its specific fields.

  • Enable the connector. It is also possible to ping the Connector to check if it works.

 Properties

image-2024-2-7_9-6-51.png


  • LogExt:  See LogExt.

  • Status : Connection status.

  • Enabled : Enable/Disable the component.

  • Fault Cause : The error message status.

  • Health: Status of the connector

  • AlarmSourceInfo: Allows to configure the alarm if there an error on ping

  • Monitor: allows to monitor the connector for problems. Note: The implementation of the ping and the alarm functionality in the monitor is connector-specific.Ping Enabled: enable pinging when there's a problem.Ping Frequency: the frequency at which to pingAlarm on Failure: enable alarms when there's a failureStartup Alarm Delay: the delay to startup the alarm

  • LicenseMonitor: Component checking the license of the connector


Advanced Config

  • Nan Values Policy: The policy for nan values (send or ignore).

  • Infinite Values Policy: The policy for Infinite values (send or ignore).


Actions

  • Ping : Ping the Service.


Fault Causes

  • Unable to connect : Check your connection data, correct them if needed and ping the Connector again